Mudder Quartz Clock Movement with Hands to Fit Dials up to 40 cm/ 15.7 Inches in Diameter (Shaft Length 3/5 inch/15mm)

Mudder quartz clock movement with hands to fit dials up to 40 cm/ 15.7 inches in diameter
DIY supply:
This item is suitable for repairing, replacing the broken parts of a clock or making a clock by yourself.
Application range:
The jump second movement are suitable for different thickness clock panel, and fit for cross-stitch, three-dimensional embroidery, craft clock, frame-less draw clock, and specially suitable for DIY quartz wall clock
Note:
Please do not install the minute hand and hour hand with too much pressure or they will be bent.
Specification:
Color: black
Material: plastic and aluminum
Power: 1.5 V AA battery (not included)
Dimensions:
Case size: approx. 55 x 55 x 16 mm (2.2 x 2.2 x 0.65 inches)
Total hour hand length: approx. 172 mm (6.8 inches)
Total minute hand length: approx. 207 mm (8.1 inches)
Second caps: approx. 7 mm (0.3 inch)
Package included:
1 x Quartz clock movement
1 x Second caps
1 x Minute hand
1 x Hour hand
1 x Plastic washer
1 x Brass washer
1 x Brass nut
Product Features
- Measurement: hand length: total hour hand length: approx. 172 mm (6.8 inches); Total minute hand length: approx. 207 mm (8.1 inches); Second caps: approx. 7 mm (0.3 inch)
- Size: total shaft length: 15 mm (3/ 5 inch); Thread length: 6.7 mm (7/ 25 inch); Jump second movement, suitable for 1 – 4 mm (1/ 24 – 4/ 25 inch) thickness clock panel
- Wide application: they are fit for cross-stitch, three-dimensional embroidery, craft clock, frame-less draw clock, and specially suitable for DIY quartz wall clock replacement movement parts, etc.
- Good DIY clock supply: suitable for repairing, replacing the broken parts of a clock or serving as good handwork material to make a clock by yourself
- Warm notice: there are some clock parts made of aluminum, please do not install them with too much pressure or they will be bent

Keeps accurate time
Made it work This manufacturer, along with all the others I checked out, need to find a better measuring system. I tried my best to figure out the 2/5 or 4/5 or whatever of an inch (is this supposed to be 3/16 or ll/16 or what????). Anyway, the stem that looked closest to my needs was too short, but I used the parts from the old one and the new one and made it work. And it is working; it’s much quieter than the old one and the new hands are larger than the old ones (old ones wouldn’t fit), but only I…